Docs/Counter-Strike 2/Fecurity

Fecurity — setup & guide

Install, activate and run Fecurity for Counter-Strike 2, with troubleshooting and FAQ. View the product →

Overview

Fecurity is our legit-to-rage Counter-Strike 2 ESP and aimbot, in an external or internal build. The pull is a clean enemy-only ESP that keeps your screen readable in a 5v5, aim you can tune to feel human with separate horizontal and vertical speed, and round automation like auto-accept. It loads at a low level, so the first run reboots your PC once; after that it auto-injects. This guide is usage-level only. Your loader and key live in your account.

Before you start

  • Windows 10 or 11 (25H2 included) with the Steam copy of Counter-Strike 2 installed and updated.
  • Run CS2 in fullscreen borderless.
  • Intel or AMD CPU. Note the AMD Ryzen 1000, 2000 and 3000 series are not supported. Check your chip before you buy.
  • An active Fecurity subscription and your license key, both in your account after purchase.
New to cheats? Read Before You Use Any Cheat first. The first launch reboots your PC, so save your work before you start. Fecurity runs on Valve matchmaking and Premier; Faceit and ESEA use kernel-level anti-cheat and carry more risk, so stay on the legit end there.

Install & activate

  1. Run the loader as administrator from your account.
  2. Enter your key and press Enter. It verifies the license.
  3. Reboot when prompted. Press any key to restart. The first boot can take a while (up to about 10 minutes on older machines), so leave the PC alone until it finishes.
  4. Launch Counter-Strike 2 after the reboot, in fullscreen borderless. Fecurity auto-injects; there's no console to keep open.
  5. Press Delete in the game to open the menu.
Running the Fecurity loader as administrator
Step 1: run the loader as administrator.
The loader console asking you to enter your key
Step 2: enter your key and press Enter.
The loader confirming the license and prompting to reboot the machine
Step 3: license verified, then press a key to reboot.

Using the menu

Press Delete in-game to show or hide the menu. Work through the tabs once and save a config you trust. It persists between sessions. Both the external and internal builds share the same ESP and aim, so the settings below apply to either.

Fecurity enemy-only box and skeleton ESP marking an opponent through cover in Counter-Strike 2
Fecurity's enemy-only ESP live on a target: box, skeleton, health and armor.
  • Aimbot: for a legit profile, put the aim on a key you hold, turn the visible check on so it ignores anyone behind a wall, and draw the FOV down small so corrections stay on the enemy you're already tracking. Slow the separate horizontal and vertical speed so a kill on an AWP peek doesn't read as an instant 180, set hitbox priority and the hitscan coefficient for where rounds land, and add a short target-switch delay so it doesn't strobe between two players on a retake.
  • ESP: keep it enemy-only so you're not reading boxes on four teammates while you clear Mirage palace. Box with an optional outline, a health bar and a separate shield/armor bar, a full skeleton for which way someone's facing, plus nickname and distance. Set a max distance to cut far-side clutter on a big map like Nuke or Ancient.
  • Utility: no spread and recoil compensation flatten the AK and M4 spray so you can hold an angle through most of a mag; auto-accept means a match pop is never missed while you're tabbed out; auto-pistol and auto-jump cover the reflex plays.
  • Untrusted mode: aimed at keeping the menu and overlay out of recordings and screenshots for clean clips. Treat it as a capture aid for streaming, not as protection against a ban.

Troubleshooting

  • No menu after the reboot: make sure CS2 is in fullscreen borderless and press Delete in the game. Give the first boot the full time it needs before touching anything.
  • Boot takes a long time: that's expected on the first launch, especially on older hardware, so don't interrupt it.
  • Won't load: confirm you're not on an AMD Ryzen 1000, 2000 or 3000 series chip, which Fecurity doesn't support.
  • Screen looks cluttered: switch the ESP to enemy-only and set a max distance so only the fights that matter light up.
  • Crashes or a risky build: update CS2 and your GPU drivers, and check Fecurity shows Undetected on the status page.
Honest bit: no cheat is unbannable. We list Fecurity only while it's confirmed undetected against VAC and pull it the moment a risky patch lands. Still stuck? Open a ticket in Discord.

FAQ

Which key opens the Fecurity menu?
Delete while you're in the game, with CS2 in fullscreen borderless.
Why does Fecurity reboot my PC?
It loads at a low level, so the first run installs and reboots once. After that it auto-injects when you launch CS2 — no reboot each time.
External or internal build: which should I run?
Both ship the same ESP and aim, so it's about your setup, not features: external runs as a separate overlay, internal injects into the game. If you're unsure, start external and switch later.
Does untrusted mode make it undetectable?
No. Untrusted mode keeps the menu and overlay out of recordings and screenshots so your clips stay clean. It's a capture aid, not anti-cheat protection, and has no bearing on whether VAC can detect the cheat.
Will it run on my PC?
Intel and AMD on Windows 10 and 11 (25H2 included), with one exception: the AMD Ryzen 1000, 2000 and 3000 series are not supported.